ef5af8e6 Working gaps of radical bearings

Use of both standard radical bearings of a bent shaft, and radical bearings with the reduced size is possible. The required size of the bearing can be determined after measurement of a neck of a bent shaft.


1. Clear a back part of an insert and the place of its installation in the block of cylinders and covers of radical bearings.
2. Establish inserts on the places, at the same time the ledge on an insert has to be combined with a groove on a cover (it is specified by an arrow).
3. One of methods which assumes existence of a micrometer for measurement of diameter of openings consists in installing covers of radical bearings together with an insert on the block of cylinders and to screw them the required moment. Measure the internal diameter of each collected couple of inserts of bearings. Measure diameter of each radical neck of a bent shaft. Subtract the corresponding diameter of a radical neck of a bent shaft from the measured diameter of the bearing.
4. The second (and more exact) the method consists in using the product known as Plastigage. It is a round plastic core which contracts between an insert and a neck of a bent shaft. After removal of a cover of the radical bearing the deformed plastic core is measured by a special template which is available in Plastigage set. On the inserts installed in the block of cylinders establish a bent shaft without lubricant. Necks of a bent shaft and inserts have to be absolutely pure and dry.
5. Cut off several pieces of a plastic core of Plastigage (they have to be slightly shorter, than width of the main bearings) and establish on each neck of a bent shaft.
6. Establish covers with the lower inserts and tighten fastening bolts the required moment. In the course of measurement of a gap by Plastigage method do not rotate a bent shaft.
7. Unscrew a cover of fastening of an insert, remove it and apply a large-scale ruler to the deformed plastic core. Comparing width of the deformed plastic core to control width on a large-scale ruler, determine gap size.
8. In conclusion carefully clear Plastigage-material traces from inserts and a bent shaft.