10.2. Main transfer

Identification table of the main transfer

1. Differential with sliding restriction (0 – it is established, 1 – it is not established)

2. Transfer relation

The type of the main transfer can be determined by the plate fastening from below a casing of the main transfer.


1. Remove both half shafts.
2. Lower pipes of the exhaust system.
3. Disconnect the driveshaft from the main transfer.
4. Establish a support under the main transfer and disconnect sockets of connection of ABS sensors.
5. Turn off fixing bolts and remove the main transfer.


Installation is carried out to the sequences, the return to removal.

Check of level of oil

1. Remove a cap (V), turn off a cap (A) and check that oil was at the level of bottom edge of an opening.
2. Add oil if it is necessary, and twirl a cap till the required inhaling moment.

Gulf of oil

Fill in oil of the required type as it is specified in subsection 10.1.