| 1. Lift a back part of the car and install it on support. |
| 2. Lift the lever of the emergency brake on 6 clicks and check that both back wheels were blocked. |
|
|
3. If adjustment is necessary, lift the lever of the emergency brake on 3 clicks and weaken an adjusting nut on the balance weight (it is specified by an arrow). |
|
4. Turn a brake disk so that the opening in a disk was established over an adjusting nut on a brake guard. Having inserted the screw-driver into an opening, turn an adjusting nut so that brake shoes blocked a brake disk. Then turn off a nut so that the brake disk could rotate again. Execute the same operation on the second wheel. |
| 5. Put the adjusting clamp on the balance weight so that blocks began to block a brake disk. |
| 6. Check adjustment of the emergency brake. |
