1. Remove a weight wire from the accumulator. Unscrew screws and remove a plastic casing from the top part of a head of the block of cylinders. |
2. On engines of a turbo of low pressure remove the metal and elastic pipe connecting a final collector with a turbocharger, and on engines of a turbo of high pressure remove the pipe connecting a collector to the heat exchanger. |
|
3. Unscrew screws (are specified by shooters) fastenings of an arm of a plait of wires to the top part of an inlet collector. |
|
4. Disconnect electric sockets from sensors of cooling liquid, the fuel pump of high pressure, the sensor of a bent shaft and the sensor of excess of pressure of a collector and move an arm of a plait of wires from a collector aside. |
|
5. Remove a vacuum pipe from the valve of system of the repeated combustion of exhaust gases located on the top part of a collector. |
|
6. Unscrew a connecting nut of fastening of a pipe of supply of fuel to a nozzle. |
|
7. Unscrew a connecting nut of fastening of a pipe of supply of fuel to the fuel pump. |
|
8. Remove pipes of supply of fuel from the engine. |
|
9. Evenly and gradually unscrew bolts and remove the top part of a collector. |
|
10. To remove the lower section of an inlet collector, disconnect a vacuum pipe from the diaphragm valve. |
|
11. Unscrew a bolt of fastening of an arm of the electric socket. |
|
12. Evenly and gradually unscrew nuts of fastening and remove the lower section of a collector with laying from a head of the block of cylinders. |